R&D Specifications Form

Please take a moment to fill the following form.
You my optionally send us additional specifications by email.
Note: All fields (unless otherwise indicated) are required to process your request correctly.

First Name:
Last Name:
Job Title:(Optional)
Company Name:

Address:
Address2 (Optional):
City:
State/Province :
Postal/Zip Code:
Country:
Phone:
Fax:
E-mail Address:

Please enter your system description and specifications here:
General guidelines : 1-You can edit this form on-line and send it, or copy to your preferred editor and then email it to us. 2-Be precise with the functions, inputs and outputs of your system. Don't try to explain an implementation. For the block diagram and the cards partition, remain in the functional point of view, not in any implementation limitation, let Us the freedom for the implementation. If you already have an implementation that partially fills your requirements, you can include it for reference. 3-Remain as short as possible in all descriptions. Specify the electronics, you my include some general system descriptions for reference only. 4-Don't assume specs you don't know its meaning, we can help you to fill the blanks. _______________________________________________________________________________ System NAME =========== Configuration: ------------- Stand alone | PC dependent | Other (specify) Fixed function set | Factory programmable | Field programmable | on-line programmable Single card | Multiple cards system (specify cards functions) | as Global R&D recommend for this system (recommended) General description: -------------------- Enter here a short description of your system from the electronics point of view, you my include some general system descriptions for reference only. Interface: (if relevant) ---------- As Global R&D recommend for this system (recommended)| PC-parallel/serial port, ISA BUS, PCI BUS, USB, PCMCIA, Other (specify) BUS Functions: ---------- Enter here a FULL LIST of the functions the system (electronics) needs to perform with short description of each one. Input/Output Signals : ---------------------- Enter here a FULL LIST of inputs/outputs the system (electronics) needs to handle with short description of the function each signal. Signal "digital_input_1": Single_ended | Differential Levels: TTL CMOS ECL 3.3V 2.5V 1.8V Other (specify) Active: Low High Timing: (referred to a other signal) Impedance: The input impedance must be = | > ____ohms Notes : Must be debounced for ____mS | Other (specify) Signal "digital_output_2": Mode : Standard: TTL CMOS ECL 3.3V 2.5V 1.8V Other (specify) Open Drain: Open voltage = ___V Source current = ___mA Open Source: High voltage = ___V Sink current = ___mA Active: Low High Timing: (referred to a other signal) Signal "analog_input_3": Single_ended | Differential Input full range level : ____nV / uV / mV / V full range current: ____pA / nA / uA / mA Impedance: The input impedance must be = | > ____ohms Signal/Noise : LSB level/current : Cut-off frequency : Timing: (referred to a other signal) Notes : Other (specify) Parameters: ----------- Electrical Specifications: -------------------------- Basic block diagram: -------------------- Enviromental considerations: --------------------------- Operating temperature= 0..50 C | -25..75 C | Other (specify) Operating humidity = 10..70 % | Other (specify) ... _______________________________________________________________________________ SOW === Maximum time to complete ------------------------ If your main restriction is TIME TO MARKET then write here the requested time to complete (it will be considered as maximum). Maximum R&D phase cost ---------------------- Only if your know you are very limited in the R&D investment write here the limit, we will see if we can comply, if yes we will send you the resulting time to complete. Maximum target product cost --------------------------- Write here the pronosticated target product cost for determinated quantities, you need to succeed in the market. Documentation ------------- List here the documents you know you must (documentation also affect the cost, and time).

supplying you with your product.